The interval is a fixed number, not a judgment call
NFPA 70E does not ask an employer to feel confident about an electrical safety program. It sets intervals. An arc flash risk assessment is reviewed periodically, at a maximum of five years (NFPA 70E 130.5 (or as amended)). The electrical safety program itself is audited at intervals not exceeding three years (NFPA 70E 110.1 (or as amended)). Retraining is required at least every three years, and sooner when an employee shows a lapse or a change in the work makes the old training wrong (NFPA 70E 110.2 (or as amended)).
Two more intervals sit outside 70E and are cited just as often. Energy control procedures carry an annual periodic inspection with a written certification identifying the machine, the date and the person who performed it (29 CFR 1910.147(c)(6) (or as amended)). Personal protective equipment is inspected before each use, with test and retest on the manufacturer's stated interval (29 CFR 1910.132 (or as amended)).
None of those dates is negotiable after an incident. They are the first four items any competent investigator requests.
What the file must prove
A qualified person keeps a file that answers five questions without a single phone call.
First, a dated arc flash risk assessment for each piece of equipment, naming the method, the incident energy where calculated, the boundary applied and the reviewer.
Second, a training roster showing who was trained, on what, by whom, and the date, with retraining inside three years.
Third, a written energy control procedure for each machine with more than one energy source, or the documented exception, plus the annual inspection certification behind it.
Fourth, PPE issue and inspection records tied to the person, not to a shelf.
Fifth, the same evidence for subcontracted electrical work, because the host employer's program is what gets examined.
An interval you cannot date is an interval you cannot prove, and an unprovable interval reads to a plaintiff's expert the same way an absent one does.
Where the file usually breaks
Three failure patterns account for most of what an audit finds in electrical files.
The assessment exists but is undated, so nobody can show it was reviewed inside five years.
Retraining happened but was never recorded, so the roster stops at the original class and the three-year clock ran out unrecorded.
The energy control procedure was written for the category of machine, not the machine, so the specific disconnect, the specific stored energy and the specific verification step are missing when the equipment changes.
Each one is a documentation failure, not an electrical failure. That distinction matters, because documentation is the part any owner can fix before an incident rather than after a citation.
How the interval gets tested
The P.A.C.E. Audit is a paper audit. It reads what the company can prove in writing today, which for electrical work means walking the intervals rather than the panels. Findings come back with a named owner, the required document, and a due date. Nothing in the audit depends on a site visit; the site visit belongs to a deployment, where the written program is installed and run with the crew.
See how this applies to electrical contractors at electrical contractors, or start with the audit at the audit.
Frequently asked
- How often must an arc flash risk assessment be updated?
- At a maximum of five years under NFPA 70E 130.5 (or as amended), and immediately when the equipment, the task or the available incident energy changes enough to affect the assessment.
- Is three years the rule for both training and the program audit?
- No. Retraining is required at least every three years under NFPA 70E 110.2 (or as amended). The program audit runs on its own cycle, not exceeding three years, under NFPA 70E 110.1 (or as amended). Keep them as two separate records, because they are asked for separately.
- Does the annual lockout inspection require a written certification?
- Yes. The periodic inspection of the energy control procedure is certified in writing, identifying the machine, the date of the inspection, the employees included and the person who performed it, under 29 CFR 1910.147(c)(6) (or as amended).
This article describes a mechanism, not a legal position. Nothing in it is legal advice.
